Gauge won't start or a WiFi update failed? Reinstall KrispyGauge firmware over USB-C from Chrome or Edge. No software to install.
If your KrispyGauge won't start, you can't reach the Web UI, or a WiFi update failed, you can reinstall the firmware over USB straight from your web browser. There's no software to install.
You'll need: a computer running Chrome or Edge, and a USB-C data cable (charge-only cables won't work). This doesn't work from a phone, and may not work in Firefox or Safari.
Go to the KrispyGauge firmware page and enter your serial number and the email from your order.
Your serial number is on the box, or on the gauge under Menu → Info. If you can't get in, email [email protected] and we'll set it up for you.
Connect the gauge to your computer with the USB-C cable.
On the firmware page, click Connect. Your browser shows a list of devices.
Pick the KrispyGauge from the list and click Connect. If more than one device is listed, unplug the gauge to see which one disappears, then plug it back in.
Click Install and confirm. It takes a couple of minutes.
Don't unplug the cable or close the tab until it's finished. The gauge restarts by itself when it's done.
Reinstalling over USB may clear your settings. Reconnect to the Web UI at http://4.3.2.1 and restore your backup under Advanced → Restore, or set the gauge up again.
Try a different USB-C cable first — a charge-only cable is the most common cause. If it still doesn't show, email [email protected].